ASME STP-PT-050-2012 三个辐照接入端口插头几何尺寸和周围管壁经历蠕变的调查

上一篇: ASME VV 10.1-2012 计算固体力学中验证和批准概念的例证
下一篇: ISO/TR 10929-2012 纳米技术.多壁碳纳米管(MWCNT)试样的表征

【英文标准名称】:Specificationforradiodisturbanceandimmunitymeasuringapparatusandmethods-Methodsofmeasurementofdisturbancesandimmunity
【原文标准名称】:无线电干扰和抗干扰测量设备规范和方法.干扰和抗干扰性的测量方法
【标准号】:BSCISPR16-2-1998
【标准状态】:作废
【国别】:英国
【发布日期】:1998-11-15
【实施或试行日期】:1998-11-15
【发布单位】:英国标准学会(BSI)
【起草单位】:BSI
【标准类型】:()
【标准水平】:()
【中文主题词】:
【英文主题词】:
【摘要】:
【中国标准分类号】:L06
【国际标准分类号】:33_100_20;33_100_10;17_220_20
【页数】:112P;A4
【正文语种】:英语


Product Code:SAE ARP1256
Title:Procedure for the Continuous Sampling and Measurement of Gaseous Emissions from Aircraft Turbine Engines
Issuing Committee:E-31 Aircraft Exhaust Emissions Measurement Committee
Scope:This SAE Aerospace Recommended Practice (ARP) describes the continuous sampling and analysis of gaseous emissions from aircraft gas turbine engines. The measured gas species include carbon monoxide (CO), carbon dioxide (CO2), nitric oxide (NO), nitrogen dioxide (NO2), total hydrocarbons (CH驴 where 驴驴驴 is the hydrogen to carbon ratio of the fuel) and water vapor (H2O). This ARP excludes engine operating procedures and test modes, and is not intended for in flight testing, nor does it apply to engines operating in the afterburning mode.It is recognized that there will probably be major advances in the gas analysis measurement technology. It is not the intent of this ARP to exclude other analysis techniques, but to form the basis of the minimum amount of conventional instruments (those in common industry usage over the last fifteen years) required for the analysis of aircraft engine exhaust. It is the responsibility of the analyst to demonstrate the alternative measurement technology has comparable (or better) performance, than the techniques described in this ARP.The measurement of other exhaust gas species is beyond the scope of this ARP. It should be noted the measurement of oxygen (O2) is generally accepted as essential for assessing data quality, but is not covered by this ARP. Sulfur dioxide (SO2) is normally not measured using conventional systems but is calculated from fuel sulfur content. Again this is not covered by this ARP.